One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
A single-cable fix often means a second failure soon after. We explain the pair-replacement logic upfront.
A cable can slip its groove repeatedly if the drum itself is damaged, which we check before calling the job done.
This repair sits close to stored spring energy, which is exactly why licensed handling matters here too.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
We replace the snapped cable and its pair, then verify even tension across both sides.
Fraying cable strands are a warning sign of imminent failure. We replace before it snaps and drops the door unexpectedly.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
Tell us if the door is hanging crooked or jammed, that detail helps us prioritize the call correctly.
Cable stock on the truck means most calls avoid a second trip for parts.
We check both cables and the drums together, then quote a flat price covering the full fix.
We verify the door hangs and travels evenly before calling the repair complete.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Both cables typically get replaced together to avoid a near-term repeat call.
We treat cable failures as priority calls given the safety risk involved.
We check the drum groove condition whenever a cable keeps coming off, since replacing just the cable won't fix a bad drum.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
A snapped-cable call usually resolves in under two hours on-site.
Call now for a real appointment window, not a callback promise.
☎ Call +1-831-293-1591From one side of Glenwood Springs to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Glenwood Springs, CO